Home Automation RC-2000 User Manual download pdf (Page 5)

3. When configured as a conventional thermostat, by default this thermostat does not turn the fan on with a

call for heat. If the furnace requires the thermostat to turn the fan on with a call for heat, configure the

“System Mode” to “Fan On With Heat” under “System Options”.

4. A conventional thermostat can be configured for automatic changeover heat/cool, manual changeover

heat/cool, heat only, or cool only thermostat.

5. Refer to the “Configuration” steps under the wiring diagram for the respective HVAC system type.

6. If the thermostat or HVAC system does not perform as stated in the “Power Up” steps under the wiring

diagram for the respective HVAC system, recheck all wiring - See Troubleshooting Tips.

7. For HVAC systems with separate heating and cooling transformers, the metal jumper between

Terminal 1 (RC) and Terminal 2 (RH) on the left terminal strip must be removed – See Figure 5.

24VAC Common

24VAC Cool "HOT"

24VAC

COOL

TRANSMFOMER

24VAC Heat "HOT"

24VAC

HEAT

TRANSMFOMER

REMOVE

JUMPER

THERMOSTAT

(C)

(RH)

(RC)

For HVAC systems with separate heating and cooling transformers, the metal jumper between

Terminal 1 (RC) and Terminal 2 (RH) on the left terminal strip must be removed.

Figure 5 – Connections for heat and cool transformers - applies to all systems

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Home Automation RC-2000 User Manual Page 5